LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Power Steering System) >> Repair Instructions >> Power Steering Gear Heat Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Steering Rack
    GM293350Courtesy of GENERAL MOTORS CORP.
  1. Install the power steering gear heat shield.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the power steering gear heat shield mounting bolts.

    Tighten:  Tighten the power steering gear heat shield mounting bolts to 9 N.m (79 lb in).

  3. Install the electrical harness clip to the power steering gear heat shield.
  4. Rotate the stabilizer shaft into position.
  5. Install the stabilizer shaft links. Refer to Stabilizer Shaft Link Replacement (FE1, FE3) or Stabilizer Shaft Link Replacement (FE7) .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals