LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Power Steering System) >> Repair Instructions >> Power Brake Booster Outlet Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place a drain pan under the vehicle to catch the power steering fluid.
    2. Fig 1: View Of Master Cylinder & Hydro Boost Unit
    GM696040Courtesy of GENERAL MOTORS CORP.
  2. Remove the master cylinder retaining nuts and position the master cylinder (2) approximately six inches away from the hydro boost unit.
  3. Remove the power steering pressure outlet hose from the hydro boost unit.
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    5. Fig 2: View of Power Steering Pressure and Return Hoses
    GM337376Courtesy of GENERAL MOTORS CORP.
  5. Remove the power steering pressure outlet hose (1) from the power steering gear.
  6. Remove the power steering pressure outlet hose (2) from the vehicle.
scientia non olet · About LEMON Manuals