LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Parking Brake System) >> Repair Instructions >> Park Brake Warning Lamp Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View of Park Brake Warning Lamp Switch Mounting Bolt
GM153110Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake warning lamp switch to the park brake lever assembly. Align the pin to the locator hole.
    NOTE: Refer to Fastener Notice .
  2. Install the park brake warning lamp switch mounting bolt.

    Tighten:  Tighten the park brake warning lamp switch mounting bolt to 2.0 N.m (18 lb in).

    3. Fig 2: Removing/Installing Park Brake Lever & Cable Assembly
    GM107329Courtesy of GENERAL MOTORS CORP.
  3. Install the park brake pedal assembly to the mounting studs.
  4. Install the park brake pedal assembly mounting nuts (1, 2).

    Tighten:  Tighten the park brake pedal assembly mounting nuts to 24 N.m (18 lb ft).

  5. Connect the electrical connector to the park brake warning lamp switch.
  6. Install the left knee bolster. Refer to Driver Knee Bolster Replacement .
  7. Install the left closeout/insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  8. Install the left carpet retainer. Refer to Front Carpet Retainer Replacement .
scientia non olet · About LEMON Manuals