LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Replacement - Right Rear (JL9) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake.
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
    Fig 1: Identifying Front Brake Cable, Connector, right Rear Brake Cable & Equalizer
    GM1665542Courtesy of GENERAL MOTORS CORP.
  4. Remove the front brake cable (1) from the connector (2).
    IMPORTANT: If the equalizer (4) is damaged, replace the equalizer.
  5. Using the J 37043  , remove the right rear brake cable (3) from the equalizer (4). See Special Tools .
    Fig 2: Identifying Retaining Bolts & Retaining Clip
    GM1665546Courtesy of GENERAL MOTORS CORP.
  6. Remove the 2 retaining bolts (1) and the retaining clip (2) from the chassis.
    Fig 3: Identifying Park Brake Cable & Caliper
    GM1665547Courtesy of GENERAL MOTORS CORP.
  7. Slide the park brake cable (1) forward and remove it from the park brake actuator lever (2).
  8. Remove the park brake cable (1) from the caliper (3).
scientia non olet · About LEMON Manuals