LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Replacement - Right Rear (J55) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Ensure the cable end is hooked over the park brake actuator arm BEFORE attaching the cable to the bracket.
    Fig 1: Identifying Brake Cable End & Park Brake Cable
    GM1527110Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the park brake cable is properly attached to the actuator.
  1. Install a brake cable end (11) in the actuator arm.
  2. Install the park brake cable (12) in the in the retaining bracket.
    Fig 2: Identifying Cable-to-LH Rear Control Arm Retaining Bolt
    GM1527974Courtesy of GENERAL MOTORS CORP.
  3. Position the park cable on the rear control arm.
  4. Install the retaining bolt for the park brake cable.

    Tighten:  Tighten the retaining bolt to 24 N.m (18 lb ft).

    Fig 3: Identifying Park Brake Cable, Right Rear Frame Bracket & Connector
    GM1527106Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: In the following service procedures, ensure the locking tabs are properly seated.
  5. Install the park brake cable (14) into the right rear frame bracket (13).
  6. Install the intermediate cable (14) into the connector (15).
  7. The park brake system is self-adjusting. No cable adjustment is needed.
  8. Lower vehicle.
scientia non olet · About LEMON Manuals