LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Replacement - Left Rear (J55) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Park Brake Cable Replacement
GM1696065Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Pull down on the intermediate brake cable (4) to relieve the cable tension.
  3. Lift up on the rear tab in the connector (3) to remove the intermediate brake cable (4) from the front brake cable (2).
    4. Fig 2: Cable-to-LH Rear Control Arm Retaining Bolt
    GM1527974Courtesy of GENERAL MOTORS CORP.
  4. Remove the brake cable retaining bolt.
    5. Fig 3: Park Brake Cable Equalizer
    GM1527094Courtesy of GENERAL MOTORS CORP.
  5. Lift up the tab (7) to remove the brake cable (8) from the equalizer (6).
    6. Fig 4: LH Rear Frame Bracket
    GM1527099Courtesy of GENERAL MOTORS CORP.
  6. Using the J 37043  , remove the brake cable (10) from the mounting bracket (9). See Special Tools .
  7. Remove the brake cable (10) from the mounting bracket (9).
    Fig 5: Cable End
    GM1527977Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: In the following service procedure, push the inner brake cable forward to gain enough cable to remove it from the actuator.
  8. Remove the brake cable (12) from the actuator (11).
  9. Using the J 37043  , remove the brake cable (12) from the mounting bracket. See Special Tools .
  10. Remove the brake cable.
scientia non olet · About LEMON Manuals