LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Replacement - Left Rear (J55) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cable End
GM1527977Courtesy of GENERAL MOTORS CORP.
IMPORTANT: Ensure that the brake cable is properly seated actuator arm.
  1. Install the brake cable (12) in the actuator arm (11).
    IMPORTANT: Ensure that the brake cable is properly seated in the mounting bracket.
  2. Install the brake cable in the mounting bracket.
    3. Fig 2: Cable-to-LH Rear Control Arm Retaining Bolt
    GM1527974Courtesy of GENERAL MOTORS CORP.
  3. Position the brake cable on the rear control arm.
    NOTE: Refer to Fastener Notice .
  4. Install the retaining bolt in the rear control arm.

    Tighten:  Tighten the retaining bolt to 24 N.m (18 lb ft).

    5. Fig 3: LH Rear Frame Bracket
    GM1527099Courtesy of GENERAL MOTORS CORP.
  5. Install the brake cable (10) in the mounting bracket (9).
    6. Fig 4: Park Brake Cable Equalizer
    GM1527094Courtesy of GENERAL MOTORS CORP.
  6. Install the brake cable (8) into the equalizer (6).
  7. Bend the lock the tab (7) into the proper position.
    8. Fig 5: Parking Brake Rear Cable Replacement
    GM1696065Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: In the following service procedures, ensure the locking tabs are properly seated
  8. Install the intermediate (4) and front brake (2) cables in the connector (3).
  9. The park brake system is self-adjusting. No cable adjustment is needed.
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals