LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Hydraulic Brake System) >> Repair Instructions >> Front Brake Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Clean all dirt and foreign material from the brake hose and the brake pipe fittings.
    4. Fig 1: Removing/Installing Brake Pipe Fitting To/From Brake Hose
    GM497903Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Cap the brake pipe fitting to prevent fluid loss and contamination.
  4. Remove the brake pipe fitting from the brake hose.
    5. Fig 2: Removing/Installing Brake Hose
    GM497902Courtesy of GENERAL MOTORS CORP.
  5. Use a flat-bladed tool in order to remove the brake hose retainer from the brake hose.
  6. Remove the brake hose from the brake hose bracket.
    7. Fig 3: Brake Hose To Caliper View
    GM420705Courtesy of GENERAL MOTORS CORP.
  7. Remove the brake hose bolt from the brake caliper.
  8. Remove the brake hose from the brake caliper.
  9. Remove and discard the two copper brake hose gaskets. These gaskets may be stuck to the brake caliper and/or the brake hose end.
  10. Plug the inlet port of the brake caliper to prevent brake fluid loss and contamination.
    11. Fig 4: Locating Brake Hose Retainer Bolt
    GM420704Courtesy of GENERAL MOTORS CORP.
  11. Remove the hose bracket bolt from the strut assembly and remove the hose.
scientia non olet · About LEMON Manuals