Brake Pedal Assembly Replacement

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Replacing Brake Pedal Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedure Remove the knee bolster panel. Refer to Driver Knee Bolster Replacement . Disconnect the electrical connector for the brake pedal position sensor.
1	Accelerator Pedal Assembly Nut (Qty: 2) Tighten: 10 N.m (89 lb in)
2	Accelerator Pedal Tip: Relocate accelerator pedal to the side.
3	Brake Pedal Pushrod Retainer Clip
4	Spacer
5	Brake Pedal Assembly Nut (Qty: 4) Procedure Without disconnecting the intermediate shaft, lower the steering column to gain access to the nuts for the brake pedal mounting bracket. Refer to Steering Column Replacement . Tighten Vacuum Brake Booster: 30 N.m (22 lb ft) Hydraulic Brake Booster 36 N.m (27 lb ft)
6	Brake Pedal Procedure After the installation is complete, calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .