LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Sunroof System) >> Repair Instructions >> Sunroof Wiring Harness Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View of Sunroof Control Module
GM786926Courtesy of GENERAL MOTORS CORP.
IMPORTANT: It is only necessary to lower the headliner. Only do the steps in headliner replacement that will lower the headliner enough to gain access.
  1. Lower the headliner. Refer to Headlining Trim Panel Replacement .
  2. Remove the sunroof control module. Refer to Sunroof Control Module Replacement .
    Fig 2: View Of Tape, Sunroof Motor/Actuator & Electrical Connectors
    GM786927Courtesy of GENERAL MOTORS CORP.
  3. Remove the tape (5) securing the electrical harness to the sunroof motor/actuator (4).
  4. Disconnect the electrical connectors (1, 3) at the sunroof motor/actuator.
  5. Cut the tie straps securing the electrical harness to the drive cable tube.
    NOTE: Note the correct routing of the electrical wiring. Failure to reinstall the wiring properly could result in damage to the wiring.
  6. Disconnect the electrical harness from the rear sunroof drain hose retainers.
  7. Disconnect the electrical connector at the main body electrical harness at the rear edge of the rear shelf panel.
  8. Remove the electrical harness from the vehicle.
scientia non olet · About LEMON Manuals