LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Sunroof System) >> Repair Instructions >> Sunroof Wiring Harness Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connector to the main body electrical harness at the rear shelf panel.
    Fig 1: View Of Tape, Sunroof Motor/Actuator & Electrical Connectors
    GM786927Courtesy of GENERAL MOTORS CORP.
  2. Secure the electrical harness to the clips on the rear drain hose.
  3. Connect the electrical connectors (1, 3) to the sunroof motor/actuator (4).
  4. Secure the harness to the sunroof motor/actuator with new electrical tape (5).
    Fig 2: View of Sunroof Control Module
    GM786926Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connectors to the sunroof control module.
  6. Install the control module to the sunroof module assembly.
  7. Ensure the locking tabs are secure.
  8. Secure the electrical harness to the drive cable tube with 2 new tie wrap.
  9. Verify the operation of the sunroof.
  10. Install the headliner. Refer to Headlining Trim Panel Replacement .
scientia non olet · About LEMON Manuals