Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Do not apply battery voltage to a new sunroof motor/actuator prior to installing the motor/actuator to the sunroof module assembly.

The sunroof window must be in the full closed position.

If possible, close the sunroof window before removing the sunroof motor/actuator.
Lower the headliner at the rear in order to gain access to the sunroof motor/actuator. Refer to Headlining Trim Panel Replacement .

Fig 1: View of Electrical Connectors, Sunroof Motor/Actuator, Bolts, & Sunroof Module Assembly
Courtesy of GENERAL MOTORS CORP.
Disconnect the electrical connectors (3) from the sunroof motor/actuator (1).
Remove the bolts (5) attaching the sunroof motor/actuator (1) to the sunroof module assembly (2).
Remove the sunroof motor/actuator from the sunroof module assembly (2).