LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Sunroof System) >> Repair Instructions >> Sunroof Motor/Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View of Electrical Connectors, Sunroof Motor/Actuator, Bolts, & Sunroof Module Assembly
GM468357Courtesy of GENERAL MOTORS CORP.
  1. Manually move the sunroof window to the full closed position.
  2. Install the sunroof motor/actuator (1) to the sunroof module assembly (2).
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the bolts (5) attaching the sunroof motor/actuator to the sunroof module assembly.

    Tighten:  Tighten the bolts to 5 N.m (44 lb in).

  4. Connect the electrical connectors (3) to the sunroof motor/actuator (1).
    IMPORTANT: Verify the sunroof operation before installing the headliner.
  5. Check the sunroof window to the roof opening fit. Refer to Sunroof Window Height and Opening Fit Adjustment .
  6. Install the headliner. Refer to Headlining Trim Panel Replacement .
scientia non olet · About LEMON Manuals