LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Power Seat System) >> Diagnostic Information and Procedures >> DTC B1825, B1850, B1860, B2105, B2355, B2365, or B2375 >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

B1825/B1850/B1860/B2105/B2355/B2365/B2375 01 

If the MSM sees the analog input from this sensor is greater than 4.65 volts, the sensor will be considered out of range and the MSM will set this DTC.

B1825/B1850/B1860/B2105/B2355/B2365/B2375 06 

If the MSM sees the analog input from this sensor is less than 0.27 volt, the sensor will be considered out of range and the MSM will set this DTC.

B1825/B1850/B1860/B2105/B2355/B2365/B2375 5A 

This DTC will set, if the MSM is controlling a motor in one direction and it's position sensor is tracking the motor in the opposite direction. The sensor is either mounted or wired incorrectly, or the polarity of the motor control circuits are reversed.

scientia non olet · About LEMON Manuals