LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Power Seat System) >> Diagnostic Information and Procedures >> DTC B1735, B1740, B1745, B1750, B1755, B1760, B1815, B1820, B1830, B1835, B1840, B1845, B2085, or B2090 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the appropriate seat or lumbar adjuster switch.
  2. Ignition ON, verify the scan tool seat or lumbar switch parameters are Inactive.
    • If not Inactive, test the signal circuit that displays Active for a short to voltage. If the circuit tests normal, replace the MSM.
  3. If all circuits test normal, test or replace the appropriate seat or lumbar adjuster switch.
scientia non olet · About LEMON Manuals