LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Seat Replacement

Seat Replacement

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Seat Replacement
GM1572347Courtesy of GENERAL MOTORS CORP.
Seat Replacement

Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .

Preliminary Procedure

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Disconnect the seat belt from the front seat. Refer to Seat Belt Retractor Pretensioner Replacement - Front .
1 Front Seat Assembly Bolt (Qty: 2)
Tip: 
  1. Adjust the seat to the full forward position to gain access to the rear bolts.
  2. Remove the rear adjuster trim covers to access the bolts.

Tighten:  45 N.m (33 lb ft)
2 Seat Assembly
Tip: 
  1. Tilt the seat forward and lift up to release the front of the seat, recline the seat back if needed for clearance.
  2. Disconnect the electrical connectors.
scientia non olet · About LEMON Manuals