LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Lighting Systems) >> Repair Instructions >> Brake Pedal Position Sensor Calibration >> Calibration Procedure

Calibration Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: If the master brake cylinder has been replaced, verify that the correct pushrod is installed before attempting to calibrate the BPPS.
  1. Apply the parking brake. Ensure transmission is in Park position.
  2. Install a scan tool. Clear all BCM DTCs before proceeding.
  3. Navigate to the Vehicle Control Systems menu.
  4. Select Module Setup menu item. Select BCM menu item.
  5. Select the BPP calibration procedure and follow the directions displayed on the screen.
scientia non olet · About LEMON Manuals