Component Testing
WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Headlamp Switch
- Ignition OFF, disconnect the harness connector at the headlamp switch.
- Test for less than 2.0 ohms of resistance between the signal terminal 2 and the ground terminal 8 with the switch in the Park position.
- If not the specified value, replace the headlamp switch.
- Test for less than 2.0 ohms of resistance between the signal terminal 2 and the ground terminal 8 with the switch in the Headlamp position.
- If not the specified value, replace the headlamp switch.
Relay Test
- Ignition OFF, disconnect the relay.
- Ignition OFF, disconnect the relay.
- If the resistance is not within the specified range, replace the relay.
- Test for infinite resistance between the following terminals:
- 30 and 85
- 30 and 86
- 30 and 87
- 85 and 87
- If not the specified value, replace the relay.
- Install a 10A fused jumper wire between relay terminal 85 and B+. Install a jumper wire between relay terminal 86 and ground. Test for less than 2 ohms of resistance between terminals 30 and 87.
- If greater than the specified range, replace the relay.