LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Lighting Systems) >> Diagnostic Information and Procedures >> DTC B2575 >> Circuit/System Description

Circuit/System Description

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Voltage is applied at all times to the low beam headlamp relay from battery voltage. Two different inputs to the body control module (BCM) can turn ON the low beam headlamps. The headlamp switch and the ambient light sensor.

Automatic Headlamps Operation 

When the ambient light sensor detects a low light condition, the BCM then applies a ground to the headlamp low beam relay control circuit. This engages the headlamp relay and applies voltage through the headlamp fuses to the low beam headlamps.

Headlamp Switch Operation 

When the headlamp switch is placed in the ON position, ground is applied to the BCM through the headlamp switch circuit. The BCM then applies a ground to the headlamp low beam relay control circuit. This engages the headlamp relay and applies voltage through the headlamp fuses to the low beam headlamps.

scientia non olet · About LEMON Manuals