Washer Pump Replacement
WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS CORP. Washer Pump Replacement
| Callout |
Component Name |
| Fastener Tightening Specifications:
Refer to Fastener Tightening Specifications . Preliminary Procedures
- Remove the right front wheelhouse panel liner. Refer to Front Wheelhouse Liner Replacement
.
- Drain the washer solvent into a suitable clean container.
- Disconnect the electrical connector at the windshield washer pump.
|
| 1 |
Hose, Windshield Washer Pump |
| 2 |
Pump, Windshield Washer Tip
- Use 2 flat-bladed tools and pry upward in order to release the washer pump from the washer solvent container grommet.
- Discard the old washer pump grommet.
|
| 3 |
Grommet, Windshield Washer Pump Tip
- Install a new grommet into the washer solvent container prior to installing the new washer pump.
- Lubricate the new grommet with straight washer fluid.
|