Component Testing
WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Heated Washer Fluid Switch
- Ignition OFF, disconnect the C4 harness connector at the turn signal/multifunction switch.
- Test for infinite resistance between the signal terminal 1 and the ground terminal 2 with the switch in the open position.
- If less than infinite, replace the turn signal/multifunction switch switch.
- Test for less than 3 ohms between the signal terminal 1 and the ground terminal 2 with the switch in the closed position.
- If greater than 3 ohms, replace the turn signal/multifunction switch.