Ignition Key Cannot Be Removed from the Ignition Lock Cylinder (Floor Shift)
WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Ignition Key Cannot Be Removed from the Ignition Lock Cylinder (Floor Shift)
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you review the Steering Wheel and Column Description and Operation and perform the necessary inspections? | Go to Step 2 | Go to Steering Wheel and Column Description and Operation |
| 2 | Verify the key cannot be removed from the ignition lock cylinder. Is the key stuck in the lock cylinder? |
Go to Step 3 | System OK |
| 3 | Is the vehicle equipped with a manual transmission? | Go to Step 8 | Go to Step 4 |
| 4 | Turn the ignition key to the OFF position. Can the key be turned to the OFF position and be removed? |
Go to Step 8 | Go to Step 5 |
| 5 | Verify the adjustment of the automatic transmission shift cable. Refer to Range Selector Lever Cable Adjustment
. Can the key be turned to the OFF position and be removed? |
System OK | Go to Step 6 |
| 6 | Inspect the lock cylinder solenoid plunger and spring. Does the plunger or spring exhibit scratches or signs of wear? |
Go to Step 10 | Go to Step 7 |
| 7 | Verify the electrical operation of the ignition lock cylinder solenoid. Refer to Ignition Can/Cannot Be Turned Off with Transmission in Any Gear . Can the key be turned to the OFF position and be removed? |
System OK | Go to Step 8 |
| 8 | Inspect for a faulty lock cylinder. Is the lock cylinder damaged? |
Go to Step 11 | Go to Step 9 |
| 9 | Inspect the ignition lock cylinder case. Is the case worn, damaged or loose? |
Go to Step 12 | Go to Step 13 |
| 10 | Replace the ignition lock cylinder solenoid and spring. Refer to Ignition Lock Cylinder Solenoid Replacement
. Did you complete the repair? |
Go to Step 13 | - |
| 11 | Replace the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement
. Did you complete the repair? |
Go to Step 13 | - |
| 12 | Replace the ignition lock cylinder case housing. Refer to Ignition Lock Cylinder Case Replacement
. Did you complete the repair? |
Go to Step 13 | - |
| 13 | Operate the system to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |