Ignition Key Cannot Be Removed from the Ignition Lock Cylinder (Column shift)
WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Ignition Key Cannot Be Removed from the Ignition Lock Cylinder (Column shift)
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you review the Steering Wheel and Column Description and Operation and perform the necessary inspections? | Go to Step 2 | Go to Steering Wheel and Column Description and Operation |
| 2 | Verify that the key cannot be removed from the ignition lock cylinder. Is the key stuck in the lock cylinder? |
Go to Step 3 | System OK |
| 3 | Is the vehicle equipped with a manual transmission? | Go to Step 7 | Go to Step 4 |
| 4 | Turn the ignition key to the OFF position. Can the key be turned to the OFF position and be removed? |
Go to Step 7 | Go to Step 5 |
| 5 | Verify the adjustment of the automatic transmission cable. Refer to Range Selector Lever Cable Adjustment
. Can the key be turned to the OFF position? |
System OK | Go to Step 6 |
| 6 | Inspect the linear shift assembly and cable for damage. Is the linear shift assembly or cable damaged? |
Go to Step 9 | Go to Step 7 |
| 7 | Inspect for a faulty lock cylinder. Is the lock cylinder damaged? |
Go to Step 10 | Go to Step 8 |
| 8 | Inspect the ignition lock cylinder case. Is the case worn, damaged, or loose? |
Go to Step 11 | Go to Step 12 |
| 9 | Replace the linear shift assembly. Refer to Linear Shift Assembly Replacement
. Did you complete the repair? |
Go to Step 12 | - |
| 10 | Replace the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement
. Did you complete the repair? |
Go to Step 12 | - |
| 11 | Replace the ignition lock cylinder case housing. Refer to Ignition Lock Cylinder Case Replacement
. Did you complete the repair? |
Go to Step 12 | - |
| 12 | Operate the system to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |