LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Disc Brake System) >> Repair Instructions >> Brake Caliper Bracket Replacement - Front (J55) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Brake Caliper And Caliper Bracket
    GM178630Courtesy of GENERAL MOTORS CORP.
  1. Remove the brake caliper from the mounting bracket and support the brake caliper (2) with heavy mechanic's wire (1), or equivalent; do NOT disconnect the hydraulic brake flexible hose from the caliper. Refer to Front Brake Caliper Replacement (J55)  or Front Brake Caliper Replacement (JL9) .
  2. Remove the brake pads from the brake caliper bracket.
  3. Remove the brake pad retainers from the brake caliper bracket.
    4. Fig 2: Locating Caliper Mounting Brackets
    GM680323Courtesy of GENERAL MOTORS CORP.
  4. Remove the brake caliper bracket bolt (1).
  5. Remove the brake caliper bracket from the steering knuckle assembly.
  6. Use a wire brush to clean any debris or rust from the brake caliper bracket.
    7. Fig 3: View Of Brake Caliper Mounting Bracket
    GM369671Courtesy of GENERAL MOTORS CORP.
  7. Inspect the caliper mounting bracket for cracks or damage. Refer to Brake Caliper Inspection .

    .

  8. Replace the brake caliper bracket if cracked or damaged.
scientia non olet · About LEMON Manuals