LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement (FE7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the stabilizer shaft links. Refer to Stabilizer Shaft Link Replacement (FE1 and FE3)  or Stabilizer Shaft Link Replacement (FE7) .
    3. Fig 1: View Of Stabilizer Shaft, Brackets & Bolts (FE7)
    GM568063Courtesy of GENERAL MOTORS CORP.
  3. Remove the stabilizer shaft bracket bolts.
  4. Bend open the end of the stabilizer shaft bracket and slide over the stabilizer shaft insulators.
  5. Remove the stabilizer shaft insulators.
  6. Remove the stabilizer shaft.
scientia non olet · About LEMON Manuals