LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement (FE1 and FE3) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: View of Stabilizer Shaft Bracket
    GM472982Courtesy of GENERAL MOTORS CORP.
  2. Remove the stabilizer shaft bracket bolt.
  3. Bend open the end of the stabilizer shaft bracket upward and remove the stabilizer shaft bracket.
  4. Using a pry bar, move the stabilizer shaft rearward and remove the stabilizer shaft stabilizer shaft insulator.
scientia non olet · About LEMON Manuals