LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement (FE1 and FE3) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View of Stabilizer Shaft & Insulators
GM105022Courtesy of GENERAL MOTORS CORP.
  1. Using a pry bar, move the stabilizer shaft rearward and Install the stabilizer shaft insulator.
  2. Install the stabilizer shaft insulator in the stabilizer shaft bracket with the slit facing forward.
  3. Bend the stabilizer shaft bracket downward to close around the stabilizer shaft insulator.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
    IMPORTANT: Ensure the stabilizer shaft is centered before installing the stabilizer shaft bracket bolts.
  4. Install the stabilizer shaft bracket bolts.

    Tighten:  Tighten the stabilizer shaft bracket bolts to 33 N.m (24 lb ft).

  5. Lower the vehicle.
scientia non olet · About LEMON Manuals