LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Rear Suspension System) >> Repair Instructions >> Rear Body Mount Replacement (FE7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Suspension And Mounting Bolts
GM105036Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tires and the wheels. Refer to Tire and Wheel Removal and Installation .
  3. Using a block of wood and a suitable jack, support the exhaust and the rear support assembly.
    4. Fig 2: View Of Support Assembly & Bolts
    GM154308Courtesy of GENERAL MOTORS CORP.
  4. Remove the exhaust system. Refer to Exhaust System Replacement .
    5. Fig 3: View Of Center Support Brackets
    GM475482Courtesy of GENERAL MOTORS CORP.
  5. Remove the center support brackets (1).
  6. Remove the two rear support assembly bolts.
  7. Lower the rear of the support assembly.
    8. Fig 4: Removing/Installing Rear Body Mount
    GM105039Courtesy of GENERAL MOTORS CORP.
  8. Remove the two bolts at the body mount.
  9. Remove the rear body mount.
scientia non olet · About LEMON Manuals