LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Rear Suspension System) >> Repair Instructions >> Rear Body Mount Replacement (FE1 and FE3) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Suspension And Mounting Bolts
    GM105036Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tires and the wheels. Refer to Tire and Wheel Removal and Installation .
  3. Using a block of wood and a suitable jack, support the rear support assembly.
  4. Remove the 2 rear support assembly bolts.
    5. Fig 2: View Of Support Assembly & Bolts
    GM154308Courtesy of GENERAL MOTORS CORP.
  5. Remove the exhaust system. Refer to Exhaust System Replacement .
  6. Lower the rear of the support assembly.
    7. Fig 3: Removing/Installing Rear Body Mount
    GM105039Courtesy of GENERAL MOTORS CORP.
  7. Remove the 2 bolts at the body mount.
  8. Remove the rear body mount.
scientia non olet · About LEMON Manuals