LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Rear Suspension System) >> Repair Instructions >> Forward Body Mount Replacement (FE1 and FE3) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Support Bracket Retaining Bolts
GM105035Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle and suitably support. Refer to Lifting and Jacking the Vehicle .
  2. Remove the wheels and the tires. Refer to Tire and Wheel Removal and Installation .
  3. Remove the exhaust system. Refer to Exhaust System Replacement .
  4. Support the forward end of the rear suspension support with a suitable jack.
  5. Remove the forward body mount brackets at the support assembly.
  6. Remove the two bolts securing the front of the support assembly to the vehicle.
  7. Lower the jack to allow the front end of the support assembly to lower enough to allow for removal of the mounts.
    Fig 2: Removing Forward Body Mount
    GM105037Courtesy of GENERAL MOTORS CORP.
  8. Using a punch, bend the tabs on the mount inboard (1) and then tap the mount downward and out of the support assembly.
scientia non olet · About LEMON Manuals