LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Rear Suspension System) >> Repair Instructions >> Adjustment Link Replacement (FE1 and FE3) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Adjustment Link To Lower Control Arm
GM397546Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    IMPORTANT: Hold the adjustment link studs with the hex tool.
  2. Remove the hex nut from the adjustment link.
    3. Fig 2: Using J 24319-B To Disconnect Outer Tie Rod From Steering Knuckle
    GM643351Courtesy of GENERAL MOTORS CORP.
  3. Use the J 24319-B  to separate the adjustment link from the control arm.
  4. Remove the exhaust. Refer to Exhaust System Replacement .
  5. Remove the rear suspension support. Refer to Support Replacement - Rear (W/FE1, FE3) or Support Replacement - Rear (W/FE7) .
    6. Fig 3: Loosening Inner Adjustment Link Retaining Nut
    GM105028Courtesy of GENERAL MOTORS CORP.
  6. Remove the cam lock nut and the bolt.
  7. Remove the adjustment link from the support assembly.
scientia non olet · About LEMON Manuals