LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Rear Suspension System) >> Repair Instructions >> Adjustment Link Replacement (FE1 and FE3) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Loosening Inner Adjustment Link Retaining Nut
GM105028Courtesy of GENERAL MOTORS CORP.
  1. Install the adjustment link to the support assembly.
    NOTE: Refer to Fastener Notice .
  2. Install the cam lock nut, washer and bolt.

    Tighten:  Tighten the cam lock nut to 91 N.m (67 lb ft).

    Fig 2: View Of Adjustment Link To Lower Control Arm
    GM397546Courtesy of GENERAL MOTORS CORP.
  3. Install the adjustment link to the control arm.
  4. Install the adjustment link nut.

    Tighten:  Tighten the nut to 30 N.m (22 lb ft) then tighten an additional 180 degrees.

  5. Install the rear suspension support. Refer to Support Replacement - Rear (W/FE1, FE3) or Support Replacement - Rear (W/FE7) .
  6. Install the exhaust. Refer to Exhaust System Replacement .
  7. Lower the vehicle.
  8. Check the rear toe adjustment. Refer to Rear Toe Adjustment (FE1, FE3) or Rear Toe Adjustment (FE7) .
scientia non olet · About LEMON Manuals