Conditions for Setting the DTC

All of the following conditions must exist for 5 seconds:

B0081 0F

• The SDM has received a fault present message from the PPS.
• The PPS is in assembly plant mode.

B0081 3A 

The SDM has received a message from the PPS which indicates a vehicle and PPS mismatch.

B0081 4B 

The PPS has failed the Rezeroing procedure.

B0081 5A

• The PPS has lost communications with the SDM.
• When the PPS has requested the passenger air bag indicator to change states (from ON to OFF or OFF to ON) and the SDM change states message does not match with the PPS message.
• After the PPS change states, the SDM signal stating the Passenger Status Data Received is not valid within 2.6 seconds.

B0081 39

• The SDM has received a NOK message from the PPS.
• The SDM has not received a message.

B0081 71 

The SDM has received invalid serial data from the PPS.