LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Exhaust System) >> Repair Instructions >> Exhaust System Insulator, Hanger, Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Exhaust Hanger & Tail Pipe Hanger Rod
GM722481Courtesy of GENERAL MOTORS CORP.
  1. Apply a soapy solution to the rear hanger rod and the inner diameter of the rear exhaust hanger in order to ease the installation of the hanger.
  2. Press the rear exhaust hanger over the tail pipe hanger rod.
    3. Fig 2: View Of Rear Exhaust Hanger To Rear Exhaust Hanger Bracket
    GM1670485Courtesy of GENERAL MOTORS CORP.
  3. Position the rear exhaust hanger to the rear exhaust hanger bracket.
    NOTE: Refer to Fastener Notice .
  4. Install the rear exhaust hanger to hanger bracket nut.

    Tighten:  Tighten the nut to 30 N.m (22 lb ft).

    5. Fig 3: Removing/Installing Exhaust Hanger
    GM694211Courtesy of GENERAL MOTORS CORP.
  5. Apply a soapy solution to the exhaust pipe hanger rod and the inner diameter of the center exhaust hanger in order to ease the installation of the hanger.
  6. Press the exhaust hanger over the exhaust pipe hanger rod.
    7. Fig 4: View Of Exhaust Hanger To Rear Suspension Support Bracket Bolt
    GM1670483Courtesy of GENERAL MOTORS CORP.
  7. Install the exhaust hanger to the rear suspension support bracket bolt.

    Tighten:  Tighten the bolt to 30 N.m (22 lb ft).

  8. Lower the vehicle.
scientia non olet · About LEMON Manuals