LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Exhaust System) >> Repair Instructions >> Catalytic Converter Heat Shield Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: In order to avoid being burned, do not service the exhaust system while it is still hot. Service the system when it is cool.
CAUTION: Always wear protective goggles and gloves when removing exhaust parts as falling rust and sharp edges from worn exhaust components could result in serious personal injury.
Fig 1: View Of Catalytic Converter Heat Shield
GM1670478Courtesy of GENERAL MOTORS CORP.
CAUTION: Eye protection must be worn when drilling rivets to reduce the chance of personal injury.
  1. Remove the exhaust system. Refer to Exhaust System Replacement .
  2. Drill out the heat shield rivets (2).
  3. Remove the heat shield.
scientia non olet · About LEMON Manuals