LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Exhaust System) >> Repair Instructions >> Catalytic Converter Heat Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Catalytic Converter Heat Shield
GM1670478Courtesy of GENERAL MOTORS CORP.
  1. Position the heat shield to the floor panel.
  2. Using a rivet gun, install the rivets (2), except for this location (1), this rivet will be installed with the oxygen sensor heat shield.
  3. Install the exhaust system. Refer to Exhaust System Replacement .
scientia non olet · About LEMON Manuals