LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Control System & Fuel System - 4.6L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Harness Electrical Connectors
    GM1662120Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield, if necessary. Refer to Fuel Injector Sight Shield Replacement .
  2. Disconnect the engine harness electrical connector (4) from the manifold absolute pressure (MAP) sensor.
    3. Fig 2: Identifying MAP Sensor Bracket & Bolt
    GM1564200Courtesy of GENERAL MOTORS CORP.
  3. Remove the MAP sensor bracket bolt.
  4. Remove the MAP sensor bracket.
  5. Remove the MAP sensor.
scientia non olet · About LEMON Manuals