LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Control System & Fuel System - 4.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Filler Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Filler Hose
    GM1671974Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel fill hose to the fuel tank. Ensure that the notch (3) in the fill hose is aligned with the notch on the fuel tank.
    2. NOTE: Refer to Fastener Notice .
  2. Tighten the fuel fill hose clamp (1) at the fuel tank.

    Tighten:  Tighten the fuel filler hose clamp to 4 N.m (35 lb in).

  3. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals