LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Control System & Fuel System - 4.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Wiring Harness Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fuel Tank Electrical Harness Connectors
    GM1671759Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel level sensor wiring harness.
  2. Connect the fuel level sensor wiring harness electrical connectors to the pressure sensor and module.
  3. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals