LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Control System & Fuel System - 4.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Pump Module
    GM1671973Courtesy of GENERAL MOTORS CORP.
  1. Slide the fuel level sensor (3) up onto the bucket, gently lift up on the locking tab (2) and continue sliding the sensor up until it engages the tab.
  2. Connect the fuel level sensor electrical connector (1) under the module cover. Push up the connector until the clip engages.
  3. Install the fuel pump module. Refer to Fuel Sender Assembly Replacement .
scientia non olet · About LEMON Manuals