LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Control System & Fuel System - 4.6L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying EVAP Canister Vent Solenoid Valve
    GM1672170Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister vent solenoid valve.
    2. Fig 2: Identifying EVAP Canister
    GM1672169Courtesy of GENERAL MOTORS CORP.
  2. Rotate the EVAP canister vent solenoid valve clockwise until the solenoid valve comes to a stop in the retainer.
  3. Install the evaporative emission (EVAP) canister. Refer to Evaporative Emission Canister Replacement .
scientia non olet · About LEMON Manuals