LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Control System & Fuel System - 4.6L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Canister Purge Solenoid Valve & Bolt
    GM1564197Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Be sure to install a NEW O-ring on the EVAP purge solenoid valve.
  1. Install the EVAP canister purge solenoid valve.
    2. NOTE: Refer to Fastener Notice .
  2. Install the EVAP canister purge solenoid valve bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb ft).

    3. Fig 2: Locating Engine Harness Electrical Connectors
    GM1662118Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine harness electrical connector (1) to EVAP canister purge solenoid valve.
    4. Fig 3: Fuel Feed & EVAP Line
    GM1662130Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP pipe (2) quick connect fitting to the EVAP canister purge solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service .
  5. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals