LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Control System & Fuel System - 4.6L - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying CKP Sensor Wiring Harness Electrical Connector
    GM1672558Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold. Refer to Intake Manifold Replacement .
  2. Disconnect the crankshaft position (CKP) sensor wiring harness electrical connector (1) from the CKP sensor.
    3. Fig 2: Locating CKP Sensor Wiring Harness Electrical Connector
    GM1672560Courtesy of GENERAL MOTORS CORP.
  3. Remove the CKP sensor bolt. (cylinder heads shown removed, for clarity).
  4. Remove the CKP sensor.
scientia non olet · About LEMON Manuals