LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Control System & Fuel System - 4.6L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying CMP Sensor Wiring Harness Connector
    GM1672927Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the electrical connector (1) from the camshaft position (CMP) sensor.
    2. Fig 2: Identifying CMP Sensor
    GM1672561Courtesy of GENERAL MOTORS CORP.
  2. Remove the CMP sensor bolt.
  3. Remove the CMP sensor.
scientia non olet · About LEMON Manuals