LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Control System & Fuel System - 4.6L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Outlet Duct Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Air Cleaner Outlet Duct
    GM1670799Courtesy of GENERAL MOTORS CORP.
  1. Install air cleaner outlet duct to the vehicle and the MAF/IAT sensor.
    2. NOTE: Refer to Fastener Notice .
  2. Tighten the air cleaner outlet duct clamp at the MAF/IAT sensor.

    Tighten:  Tighten the clamp to 4 N.m (35 lb in).

    3. Fig 2: View Of Air Cleaner Outlet Duct To Throttle Body
    GM1670790Courtesy of GENERAL MOTORS CORP.
  3. Install the air cleaner outlet duct to the throttle body.
  4. Tighten the air cleaner outlet duct clamp at the throttle body.

    Tighten:  Tighten the clamp to 4 N.m (35 lb in).

    5. Fig 3: Identifying PCV Fresh Air Tube
    GM1661022Courtesy of GENERAL MOTORS CORP.
  5. Connect the PCV fresh air tube quick connect fitting to the air cleaner outlet duct. Refer to Plastic Collar Quick Connect Fitting Service .
    6. Fig 4: Locating MAF/IAT Sensor Connector
    GM1670786Courtesy of GENERAL MOTORS CORP.
  6. Connect the engine harness electrical connector to the MAF/IAT sensor.
scientia non olet · About LEMON Manuals