LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement (FE7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Stabilizer Link Insulators, Washers, Nut, & Bolt
GM474719Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheels. Refer to Tire and Wheel Removal and Installation .
  3. Remove the stabilizer links. Refer to Stabilizer Shaft Link Replacement (FE1, FE3)  or Stabilizer Shaft Link Replacement (FE7) .
    4. Fig 2: View Of Stabilizer Shaft Brackets & Bolts
    GM474720Courtesy of GENERAL MOTORS CORP.
  4. Remove the stabilizer shaft bracket bolts.
  5. Remove the stabilizer shaft brackets.
    6. Fig 3: Using J 24319-B To Disconnect Outer Tie Rod From Steering Knuckle
    GM643351Courtesy of GENERAL MOTORS CORP.
  6. Remove the outer tie rod retaining nuts.
  7. Using J 24319-B  , disconnect the outer tie rod from the steering knuckle.
  8. Separate the ball joint. Refer to Lower Ball Joint Replacement (FE1, FE3)  or Lower Ball Joint Replacement (FE7) .
  9. Turn the right steering knuckle to the left, and guide the stabilizer shaft half out the right side of the vehicle in an upward direction, then remove the stabilizer shaft out the bottom center of the vehicle.
scientia non olet · About LEMON Manuals