LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement (FE7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Installing Ball Joint
GM1654298Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft to the vehicle.
  2. Install the ball joint to steering knuckle. Refer to Lower Ball Joint Replacement (FE1, FE3)  or Lower Ball Joint Replacement (FE7) .
    NOTE: Refer to Fastener Notice .
  3. Install the ball joint retaining nut.

    Tighten:  Tighten the ball joint retaining nut to 30 N.m (22 lb ft) plus an additional 210 degrees.

    4. Fig 2: View Of Stabilizer Shaft Brackets & Bolts
    GM474720Courtesy of GENERAL MOTORS CORP.
  4. Loosely install the right and left stabilizer shaft insulators, brackets, and bolts.
    5. Fig 3: View Of Stabilizer Link Insulators, Washers, Nut, & Bolt
    GM474719Courtesy of GENERAL MOTORS CORP.
  5. Loosely install the stabilizer link insulators, washers, nut, and bolt.
  6. Install the tie rod to steering knuckle.

    Tighten: 

    • Tighten the stabilizer bracket bolts to 50 N.m (37 lb ft).
    • Tighten the stabilizer link nut to 23 N.m (17 lb ft).
    • Tighten the tie rod end to knuckle nut to 30 N.m (22 lb in) plus an additional 200 degrees.

  7. Install the cotter pin in tie rod ends.
  8. Install the front wheels and tires. Refer to Tire and Wheel Removal and Installation .
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals