LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement (FE1 and FE3) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front wheels and tires. Refer to Tire and Wheel Removal and Installation .
  3. Remove the stabilizer shaft links. Refer to Stabilizer Shaft Link Replacement (FE1, FE3)  or Stabilizer Shaft Link Replacement (FE7) .
  4. Remove the stabilizer shaft insulators. Refer to Stabilizer Shaft Insulator Replacement (FE1, FE3)  or Stabilizer Shaft Insulator Replacement (FE7) .
    5. Fig 1: Removing Outer Tie Rod Assembly From Steering Knuckle
    GM643351Courtesy of GENERAL MOTORS CORP.
  5. Remove the left outer tie rod end retaining nut.
  6. Using J 24319-B  disconnect the outer tie rod end from the steering knuckle.
  7. Remove the exhaust manifold pipe. Refer to Exhaust Manifold Pipe Replacement - Rear .
    8. Fig 2: View of Stabilizer Shaft
    GM144023Courtesy of GENERAL MOTORS CORP.
  8. Turn the left strut completely to the left. Guide the stabilizer shaft out the left side of the vehicle between the axle and the lower control arm.
  9. Remove the stabilizer shaft (3) out from under the vehicle.
scientia non olet · About LEMON Manuals