Installation Procedure
WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the stabilizer shaft (3) to the vehicle.
- Install the exhaust manifold pipe. Refer to Exhaust Manifold Pipe Replacement - Rear .
- Loosely install the following components:
- The left and right stabilizer shaft insulators
- The brackets
- The bolts
- Install the stabilizer shaft links. Refer to Stabilizer Shaft Link Replacement (FE1, FE3) or Stabilizer Shaft Link Replacement (FE7) .
- Install the left tie rod end (1) to the steering knuckle.NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
- Install the left outer tie rod retaining nut.
Tighten:
- Tighten the stabilizer shaft insulator bracket bolts to 33 N.m (24 lb ft).
- Tighten the outer tie rod end to steering knuckle to 30 N.m (22 lb ft) + 200 degrees.
- Install the front wheels and tires. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.