LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Engine Mechanical - 4.6L - 1 Of 4) >> On-Vehicle Repair Instructions (1 Of 2) >> Valve Lifter Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Valve Lifter
    GM240801Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not stroke/cycle the stationary hydraulic lash adjuster plunger without oil in the lower pressure chamber.
  1. Fill the stationary hydraulic lash adjuster (SHLA) with clean engine oil. Refer to Sealers, Adhesives, and Lubricants . Take precautions to prevent scratching the pivot sphere area (1) of the SHLA.
    2. Fig 2: Locating Left Stationary Hydraulic Lash Adjusters (SHLA)
    GM522867Courtesy of GENERAL MOTORS CORP.
  2. Install the new SHLA's into the bores.
  3. Install the left valve rocker arms. Refer to Valve Rocker Arm Replacement - Left Side .
scientia non olet · About LEMON Manuals